To determine the correct dimensions, we must consider:
A. the window dimensions
B. the display system (tracks or rods)
C. the type of hanging/crease ratio (tape, rings, tabtops or eyelats)

The width of the curtain or sheer is determined by the chosen display system (tracks or rods);
The height (length / fall) of the curtain or sheer is influenced by both the display system and personal preferences regarding how to place the material above the floor.

For the most accurate measurement, we recommend that you always use a tape measure!
For precise dimensions, please follow the information from our guide:

If the display system is not installed (tracks or rods), we recommend to measure the curtains and sheers after the actual installing of the display system.

How to install the display system:

1. Gallery with track or rods installed on the wall:
To determine the position where the wall brackets will be attached - in terms of height, the distance between the top of the window and the ceiling will be measured. So, half of this distance is the optimal place where the brackets can be installed on the wall. To determine the position of the bracket on the sides of the window, the total width of the window must be measured, to which is added 15-20 cm on each side of the window.

2. Gallery with track or rods installed on the ceiling:
To determine the position of the bracket for the ceiling rod, at least 6 cm from the wall to the point of fixing of the bracket shall be taken into account; For cases where there is a radiator under the window, to determine the position where you need to install the bracket, we recommend you to measure the distance from the wall to the front of the radiator, to which is added 2 or 3 cm.
The recommended distance between the brackets for the ceiling rod is 50-70 cm.

Depending on the size of the windows, must be considered the following:
• The curtain and the sheer should exceed by 15-20 cm the edge of the window on each side of the window;
• We recommend, for an aesthetic and practical result, depending on the access to the door or window opening system, the width of the curtain or sheer to be divided in two pieces of fabrics;

1. Measurement of height (length) depending on the display system

Depending on the display system you have chosen, the measurements for curtains and sheers can be made as follows:

The final dimensions of the curtains and sheers are influenced by the chosen hanging system. These details can be finalized with the sales consultant, who will advise you in choosing the right method of creasing according to your preferences.

Below, you can find some of the best creasing options. For more information, please contact your sales consultant:

The Roman blinds from Mendola Fabrics can be cut to cover the entire window frame, or placed inside the window frame, directly on the carpentry.

The roman blinds can be customized to the desired dimensions. Select some Mendola Fabrics materials and please ask professional advice on choosing the right material and setting the right dimensions.